User manual

MESSAGE ALERT
The DataGuard Appliance can be configured to send e-mail or SMS
alerts when certain events occur.
To set up e-mail alerts:
1. From the Administration tab, click the Message Alert menu item.
2. Click the Policy button, then check the boxes for which alerts you
want to send. Click the Save button to apply the new settings.
3. Click the Add button, then enter an e-mail address for the intended
recipient. Click the Save button. You can also edit or delete e-mail
addresses from this panel.
4. Click the Setup button to reveal the settings panel. Check the
Enable Services box, then fill in the remaining fields for sending
messages. See the table below.
5. Click the Test button to send a test message; click the Save button
to apply the new settings, or click the Cancel button to leave this
feature inactive.
To set up SMS alerts:
1. From the Administration tab, click the Message Alert menu item.
2. Click the Policy button, then check the boxes for which alerts you
want to send. Click the Save button to apply the new settings.
3. Click the Go to SMS button, then click the Add button.
4. Select a Country Code from the pull-down menu and enter a
number in the Cell Phone Number field.
5. Click the Add button to confirm your choice, or click the Cancel
button to leave the SMS settings unchanged.
Alert Item Description
Enable Services
Check to enable message alert service.
SMTP Server
Enter the IP address of SMTP server.
SMTP Port
Enter the port number of SMTP server.
From
The sender of the notification message.
SMTP
Authentication
Check to enable or disable.
Username
Enter the username to log in the SMTP server.
Password
Enter the password to log in the SMTP server.
Administration > Message Alert > Policy
58