User manual

FRONT PANEL—R4
The front panel provides access to the hard drive carriers, power button,
and one USB 2.0 connection (USB Port 1). The bezel (shown attached)
includes an LCD display.
Feature Description
Network
LEDs
Indicators flash when network connection is active.
USB Port
Supports USB 2.0 for One-Plug-Auto-Service (OPAS), keyboard,
USB printer, USB hard drive or USB uninterruptable power
supply. This port is labeled USB1 in the Management Interface.
LCD Display
and
Controls
On front bezel. Displays name and IP address for the device.
Use with the Select and Enter buttons to view critical system
statistics or configure the IP address, Subnet Mask, or Gateway
settings.
One-Touch
Backup
Button
and LED
Initiates data backup for a client system with backup schedule
configured. When the button is pushed, the LED below flashes
amber; during backup, it blinks green; when the backup is
complete, a buzzer sounds once.
Disk Status
LED
Upper indicator glows green when the disk is functioning
normally, amber when the disk is rebuilding, and red if the disk
has failed.
Disk Activity
LED
Lower indicator flashes blue to show read/write activity.
Power
Button and
Status LED
Button powers DataGuard Appliance on and o. Status LED
on power button glows green when the power supply is
functioning normally, and amber in case of a critical disk error.
Release
Button
Allows user to release drive carrier from chassis.
Drive
Carrier
Latch
Lets user remove released carrier for installation or replacement
of hard drive.
One-Touch
Backup Button
USB Port
Network
LEDs
Disk Status
and Activity
LEDs
Drive
Carrier
Latch
Release
Button
One-Touch
Backup LED
Power
Status
LEDs
System
Status
LED
Power
Button
Bezel Release
LCD Display
4