User manual

DIAGNOSTIC

Use the Diagnostic menu to run basic function diagnostics for the

following items:

• Physical Drives (SMART)

• Network Port 1

• Network Port 2

• IP Routing

• DNS Setting

The results are presented as a simple Pass or Fail for each test. The

message ”Please Wait” will appear if the test has not yet been run.

To run the basic tests, select the Diagnostic menu item, then click the

Check button. The panel will display results similar to the image below.

Device > Diagnostic > Results

mAnAging An eXternAl drive

1. From the Device tab, click the External Drive menu item.

2. Move your pointer over the external drive on the list to select one of

the following options:

• Click View to display information about the drive.

• Click Settings to set the Write Policy (Write Through or Write

Back), then click Submit to apply the new setting, or click Cancel to

keep the current setting.

• Click Format to specify format type (FAT32, NTFS, or XFS for hard

drives or ﬂash drives, and XFS or NTFS for RDX cartridges); click

Submit to format and mount the external drive, or click Cancel to

keep the current setting.

• Click Remove to unmount the external drive, then click Conﬁrm to

apply your selection, or click Cancel to leave the drive mounted.

Device > External Drive > View

To reduce the risk of data loss, click Remove before disconnecting

a USB drive.

To reduce the risk of data loss, click Remove before disconnecting

a USB drive.