User manual

USE LCD PANEL CONTROLS
The LCD display and controls on the front panel let you monitor vital
system statistics, check the firmware version, configure IP settings,
and reboot or shut down the device. To review system status, press the
Select button repeatedly. The display will cycle through these eleven
categories of system information:
• Name/IP
• CPU Temp
• System Temp
• Fan Speed
• 12V Voltage
• 5V Voltage
• 3.3V Voltage
• System Date
• System Time
• Firmware Version
• BIOS Version
• Back/Main Page
As the Back/Main Page is displayed, you can choose from two options:
• Press the Select button once more to display the CPU Temp
option and begin the listing again, or
• Press the Enter button to return to the device name and IP address
Select Button
Enter Button
1.
✴ If you choose DHCP, the display will show the options “Cancel”
or “OK”. Press Select to switch between these two options, then
press Enter to confirm your selection.
✴ If you choose Fixed, the display will show the current IP address
with the first digit highlighted. Press Select until this digit
shows the number you want, then press Enter to confirm your
selection and move to the next digit.
✴ Follow the same procedure to set a Gateway address, then
press Enter to confirm your selection.
✴ When all numbers are set, press Enter. The display will show the
options “Cancel” or “OK”. Press Select to switch between the
two options, then press Enter to confirm your selection.
Set diSplAy lAnguAge
1. When the display shows the IP address, press Enter. The LCD will
show “Network Setting Enter?”
2. Press Select once. The LCD will show “Display Language”.
3. Press Enter to change the current display language.
4. Press Select to cycle through the available languages, then press
Enter to confirm your selection.
Set power Control FunCtionS
1. When the display shows the IP address, press Enter. The LCD will
show “Network Setting Enter?”
2. Press Select twice. The LCD will show “Power Control Enter?”
3. Press Enter once. The LCD will show “Shutown/Reboot” above and
“Shut Down?” below.
4. To switch between these options, press Select; to confirm your
selection, press Enter.
5. The LCD will show “Cancel” and “OK”.
6. To switch between these options, press Select; to confirm your
selection, press Enter.
ConFigure network SettingS
When the DataGuard Appliance is first connected to an active network,
it will retrieve an IP address automatically. A fixed (static) IP address is
recommended. If possible, specify a fixed IP address through the LCD
panel by following these steps:
1. Press Enter once. The display will show “Network Setting Enter?”
2. Press Enter again. The display will show “Network Setup”, “DHCP”
and “Fixed”.
3. Press Select to switch between DHCP and Fixed; press Enter to
confirm your selection.
10
✓
✓
✓
✓