User manual

ipv6 SettingS
To configure the DataGuard Appliance for use with the IPv6 protocol,
follow these steps:
1. From the Administration tab, click the Network menu item, then
click the IPv6 Settings button.
2. Select a Network Speed from the pull-down menu.
3. Check the Enable Service box.
4. To set IP Properties, choose one of two methods:
✴ Check the box marked Obtain an IP Address automatically; or
✴ Enter a fixed (static) IPv6 Address, Subnet Mask, Gateway IP
Address, DNS Server IP Address, and Secondary DNS Server IP
Address in the fields provided.
5. Click the Submit button to apply these settings.
mtu SettingS
If your network is configured to use maximum transmission unit
(MTU) , you can set the DataGuard Appliance to take advantage of its
capabilities. Follow these steps:
6. From the Administration tab, click the Network menu item, then
click the MTU Settings button.
7. Confirm that the Ethernet Link Mode and Ethernet Link Speed are
correct.
8. Select a maximum transmission utin from the pull-down menu.
9. Click the Submit button to apply these settings.
tCp/ip SettingS
1. From the Administration tab, click the Network menu item, then
click the TCP/IP Settings button.
2. Select a Network Speed from the pull-down menu.
3. To set IP Properties, choose one of two methods:
✴ Check the box marked Obtain an IP Address automatically; or
✴ Enter a fixed (static) IP Address, Subnet Mask, Gateway IP
Address, DNS Server IP Address, and Secondary DNS Server IP
Address in the fields provided.
4. Click the Submit button to apply these settings.
Administration > Network > TCP/IP Settings
47
✓
✓
✓
✓