User manual
dIagnoStIc
Use the Diagnostic menu to run basic function diagnostics for the
following items:
• Physical Drives (SMART)
• Network Port 1
• Network Port 2
• IP Routing
• DNS Setting
The results are presented as a simple Pass or Fail for each test. To run
the basic tests, select the Diagnostic menu item, then click the Check
button. The panel will display results similar to the image below.
Device > Diagnostic > Results
mAnAging An eXternAl drive
1. From the Device tab, click the External Drive menu item.
2. Move your pointer over the external drive on the list to select one of
the following options:
• Click View to display information about the drive.
• Click Settings to set the Write Policy (Write Through or Write
Back), then click Submit to apply the new setting, or click Cancel to
keep the current setting.
• Click Format to specify format type (FAT32, NTFS, or XFS for hard
drives or flash drives, NTFS only for RDX cartridges); click Submit
to format and mount the external drive, or click Cancel to keep the
current setting.
• Click Remove to unmount the external drive, then click Confirm to
apply your selection, or click Cancel to leave the drive mounted.
Device > External Drive > View
To reduce the risk of data loss, click Remove before disconnecting
a USB drive.
To reduce the risk of data loss, click Remove before disconnecting
a USB drive.
!
30