User manual

unInterruptIBle power Supply (upS)

Every DataGuard Appliance allows the use of an uninterruptible power

supply (UPS) that supports the APC UPS protocol. The UPS can

connected by USB or Ethernet. Follow these steps to conﬁgure UPS

features:

1. From the Device tab, click the UPS menu item.

2. Click the Setup button at the upper right.

3. Select your preferred settings for Interface, Power Off Threshold,

and IP Address.

4. To conﬁrm and apply your selections, click Submit. To return to the

current settings, click Cancel.

UPS

Settings Description

Interface

Choose the type of UPS connected to the device, USB

or Network.

Power Off

Threshold

Select the Power Off Threshold option: Disabled,

Immediate, The reserve power reaches [choose

percentage] or After running [choose time to run].

IP Address

For Network UPS systems, enter the applicable IP

address.

Device > UPS > Setup

eXternal drIve

External hard drives can be attached to the DataGuard Appliance

through any of the ﬁve USB ports, and conﬁgured through the

External Drive menu in the Management Interface. A drive that has

already been formatted will connect automatically when powered

on and connected. If a drive has not been formatted, it must ﬁrst be

formatted through the Format menu before it can be mounted.

Note: Refer to pages 3–6 for USB port locations on the

DataGuard R4 and T5R.

Device > External Drive