User manual

Figure 1

Figure 2

InStallIng Hardware

Follow the instructions below to install hard disk drives, connect the Data

Guard Appliance to the network, and power it on. If your DataGuard

Appliance shipped with hard drives already installed, use these instructions

for replacing a hard drive.

unlock and open SecurIty door (t5r only)

Using the key included, unlock the security door and open it completely.

remove drIve carrIer

1. Press the square button on the right side of a drive carrier. This will

release the latch on the left side.Hold the latch and gently pull the

carrier out of its slot. It is now ready to receive a new drive

Release Button

Drive Carrier

Latch

place new drIve In carrIer

1. Place the empty drive carrier on a table or other stable platform.

Orient the drive so that the SATA contacts and power connector

will face the rear of the enclosure (Figure 1). Place the drive in the

carrier so that the screw holes are aligned.

2. Fasten the drive to the carrier using only the counter-sink screws

provided (Figure 2). Use four screws per drive and be careful not

to over-tighten them.

✓