Instruction Manual

09 10

Mini room cleaning mode

( These functions control by remote controller)

Maintenance

Lid

Dustbin

Open the lid and

take the dustbin out

[ Cleaning the dustbin and the filter]

A) Open the lid and take the dustbin out

B) Take out the filters from dustbin --- Empty the

dustbin --- Wash the dustbin by water --- Dry

the dustbin

C) Rinse the air filter and dry it up

D) Patting / blowing the HEPA to clean it, or use

a brush to clean

Remark:

1) Switch off the robot before cleaning the robot

2) Check if there are objects in the suction intake,

clean the objects if there are any

3) The filters lasts for 24 months, please clean the filters once or twice per month

4) Make sure that the dustbin and filters are completely dry before replacing them

( Note: Do not expose the filters to direct sunlight for extended their working-life)

[ Cleaning the lateral brushes]

A) Use a soft wipes to clean the lateral brushes

B) If the brushes hair come out of shape or loose, please take the lateral brushes out

and put the brushes hair into boiled water to refresh it

C) Replace the lateral brushes if they are damaged and out of function

Note: Before replacing the lateral brushes, check the L&R markings on the two lateral

brushes, make sure they match the corresponding markings on the base housing

Charging contacts

Cliff sensors

Charing

contact

Charing

contact

[ Cleaning the cliff sensors and charging contacts]

Use a soft dry cloth to gently clean the sensors’ window and the charging contacts.

Note: Do not use water or liquid to clean the sensors or charging contacts.

Note: for the models with GYRO navigation function only