Instruction Manual

07 08
[ ON / PAUSE / OFF ]
[ SLEEP MODE ]
[ Remote control operation ]
1) Turn the robot’s Side Power Switch to the ON position, Robot will standby
2) Press the Clean Button on Robot or the START/STOP Button on the Remote Control. Robot
starts to work immediately in AUTO Cleaning Mode.( Z-type cleaning as default)
3) Pause the Robot by press the Clean Button on Robot or the START/STOP Button on the
Remote Control. (Robot will standby and save battery power)
4) If Robot not in use & not on the Charging Dock / not In Charging, it will goes to sleep mode,
and it will have voice alert when battery power lower than 20%, to avoid any disturbing casued
by that, please trun off the Robot when it is not in use for a long time.
Sleep Mode means Robot under sleep, the Clean Button on the robot does not flash and buttons
on the Remote Control are disabled.
A) If Robot is Paused for more than 60 seconds it goes to sleep to save battery power
B) press the Power Button on the Remote Control twice, Robot goes to sleep.
Note: Before cleaning, please make sure the Robot is awake, and the Clean Button is in Green
light. If Robot is not waken up, press Clean Buttuon on the Robot or “ ” Power Button on the
remote control to wake it up.
Please use 2 pcs AAA R03 batteries in the romote control, and turn the robot’s Power Switch to the
ON position.
1) Press Power Button, Robot is waken up and standby, press the Power Button again, Robot
under sleep mode.
2) Press Recharge Button, Robot return to the Charging Dock & recharge itself automatic,
“Clean” Button on the Robot keep flashing. ( For the modeles with charging dock only)
3) Press Start/Pause Button to start cleaning, press again, Robot Stopped/Paused.
4) Forward, Left, Right, move the Robot to the setting direction.
5) Wi-Fi Button: ( For the Wi-Fi models only) after turn on the Robot, press this button over
3 seconds after “DingDingDong” bell: Initialization module Smart phone WIFI setting Search
Robot WIFI : IMA - xxxx, linked, control the Robot via smart phone APP anywhere at anytime.
6) Press Max power Button, Robot will trun to max suction power mode.
7) Mini Room cleaning : This mode is applicable for a small area of concentrated dirt
or dust. Robot run with 1 meter width zigzag smart move.
8) Spot cleaning: This mode is applicable for an area of highly concentrated dirt or dust.
Robot run in a smaller Z-type cleaning mode. stops or resumes auto cleaning when it completes
spot cleaning.
9) “ ” Edge cleaning: This mode is good for cleaning the edges and corners of a room. In Edge
Cleaning Mode, Robot cleans along a border (e.g. wall).
5) Please DO NOT put anything between the charge dock and floor
6) Use the original adapter only, do not use others.
,nottub ” naelC/ tratS “ eht ot rewsna ylno lliw toboR eht ,gniegrahc rednu toboR eht nehW :etoN (
any other button will no reaction.)
Indicator of “ Clean” button during Charging:
Indicator of “ Clean” button
[ Charing Dock installation] ( For the models with charging dock only)