User's Manual

7
Connection methods
Contour 200i Air can be connected and used in different ways:
• As a docking station for an iPod, iPhone or iPad. See page 19
• As an AirPlay device for playing audio from iTunes on your computer or an iPod touch,
iPhone or iPad with AirPlay, via your wireless network. See page 11.
• As a speaker for an audio device connected via the Aux In connector. See page 20.
Switching between Sleep, Standby and On
Contour 200i Air has three power states, Standby, Sleep and On. In Standby, Contour 200i Air
uses minimal power (Status LED is bright red). In Sleep, Contour 200i Air remains connected to
the wireless network (once attached) and is waiting for a source to be selected (the Status LED is
dimmed red). Refer to page 10 for more information on the Status LED.
To enter Standby, press and hold Standby for four seconds on Contour 200i Air, or the remote
until the Status LED is bright red.
To exit Standby, press Standby to switch to Sleep. The Status LED will flash and will return to the
state that the Contour 200i Air was in before Standby.
Once in Sleep, press Standby to switch to On.
Once in On, press Source to switch between AirPlay, iPod and Auxiliary input.