User's Manual

6
Wired setup
1. Connect an Ethernet cable from
the Ethernet port on the back of
Contour 200i Air to your router.
2. Insert the connector of the mains
power adapter into the DC In
socket on the rear of Contour 200i
Air.
3. Plug in to the mains supply.
4. A network connection between your computer and Contour 200i Air will then be established
automatically. When the red Status LED on the front has stopped flashing, Contour 200i Air is
in Standby.
5. Refer to”Connection methods” on page 7 for the next setup steps.
18V DC