User's Manual

4
Getting started
Remote control setup
Pull the plastic tab from the remote control battery compartment and remove the protective film
from remote buttons.
Network setup
Contour 200i Air can be connected to your network by using a wireless or wired connection.
The wireless connection method is very flexible as it does not require an Ethernet cable to be run
between Contour 200i Air and your wireless router, allowing you to position your Contour 200i Air
anywhere within range of your wireless connection. We recommend using the wireless connection
method. Refer to “Wireless setup” on page 5 for more information.
When using the wired connection method, an Ethernet cable needs to be connected between
the Ethernet port on the back of Contour 200i Air and one of the available Ethernet ports on your
router. With this setup method, your iPad, iPod or iPhone connects to Contour 200i Air via the
wireless router. Refer to “Wired setup” on page 6 for more information.