User's Manual

Setting up AirPlay

Introduction

There are three stages in setting up Contour 200i Air to use AirPlay:

1. Create a connection between Contour 200i Air and your setup device (any device with Wi-Fi

and a browser, such as an iPhone or laptop), by using a temporary wireless network. (To

connect Contour 200i Air using a network cable see page 6).

2. Add Contour 200i Air to your wireless network using a conﬁguration web page that you can

now access on your setup device.

3. Conﬁgure iTunes, or your iPod touch, iPhone or iPad, to use Contour 200i Air as an AirPlay

device, i.e. a device you can stream audio to.

Stage 1: Connecting your setup device to Contour 200i Air

The ﬁrst stage of the setup procedure is to establish a temporary connection between your setup

device and Contour 200i Air. The connection can be established by creating a temporary wireless

network to connect to an iPod Touch, iPhone, iPad, laptop or smartphone.

Connecting using a temporary wireless network

1. Ensure that Contour 200i Air is in Sleep or On.

2. Press the Wi-Fi Setup button on the back of the Contour 200i Air for ﬁve seconds. This will

turn on Contour 200i Air’s temporary wireless network. The Status LED will ﬂash red while the

temporary wireless network starts up.

20 secs

After around twenty seconds, the Status LED will then ﬂash green and blue until the

connection to the setup device is established.

3. On your setup device (iPhone, laptop etc), the Contour 200i Air xxxxxx* wireless network

should now be visible. Select this network. No password is required.

4. Once you have connected to the Contour 200i Air xxxxxx* wireless network, you can access

the conﬁguration screen on your setup device’s web browser. Use this conﬁguration web page

to add Contour 200i Air to your own wireless network. See Stage 2.

*xxxxxx represents a six digit code that will be unique to each Contour 200i Air.