User's Manual

Listening to Internet Radio and more EVOKE Flow Owner’s Manual v1.0

View details

Select ‘View details’ to list the following technical information about the conﬁguration of the network

that EVOKE Flow is connected to:

Network name The Network Name (SSID) is shown at the top of the screen.

Encryption The encryption method is listed (WEP, WPA or WPA2).

IP address The IP address of the radio.

Net mask The conﬁgured network mask.

DNS The DNS server IP address.

Router The gateway router IP address.

Radio Name The name of the radio (see Change radio name, p.22).

MAC address The MAC address of the radio (a ﬁxed address that identiﬁes your hardware).

Access point The MAC address of the router that the radio is connected to.

Manual setup

Select ‘Manual setup’ to manually conﬁgure your wireless network settings (for advanced users only).

Retry connection Attempts to reconnect to the selected network.

Network name Choose from ‘Scan for networks’ or ‘Enter SSID manually’ to specify a new SSID

for your wireless network.

Encryption mode Change the encryption mode between ‘WEP’, ‘WPA (PSK)’, ‘WPA2 (PSK)’ or

‘None’. EVOKE Flow automatically detects the encryption mode for your network.

Only change this setting if you think the encryption mode has been speciﬁed

incorrectly.

Key or password Enter a new encryption key or password.

IP address Choose between ‘DHCP’ or ‘Static’.

Clear network settings

Select ‘Clear network settings’ and EVOKE Flow will ‘forget’ all wireless networks and perform a

fresh re-scan for visible networks. Select

‘Connection wizard’ to re-scan for wireless networks. Note

that you will have to re-enter your WEP or WPA/WPA2 key or password. You have to conﬁrm this

operation: tap O Yes to conﬁrm or O No to cancel.