® Patent Pending Model No. 831.108150 Serial No. Write the serial number in the space above for reference. USER’S MANUAL Serial Number Decal QUESTIONS? As a manufacturer, we are committed to providing complete customer satisfaction. If you have questions, or if there are missing parts, we will guarantee complete satisfaction through direct assistance from our factory. TO AVOID UNNECESSARY DELAYS, PLEASE CALL DIRECT TO OUR TOLL-FREE CUSTOMER HOT LINE.
Table of Contents Warning Decal Placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Important Safety Instructions WARNING: To reduce the risk of drowning, electric shock, or serious injury, read the following important precautions before using the spa. READ AND FOLLOW ALL INSTRUCTIONS 1. It is the responsibility of the owner to ensure that all users of the spa are adequately informed of all precautions. 13. Keep all chemicals away from children and pets. 14. The pH and chemical balance of the water must be maintained as explained in this manual (see page 13).
has been repaired or replaced by a qualified electrician. 27. DANGER—To reduce the risk of drowning: Prolonged immersion in the spa may cause hyperthermia, a dangerous condition which occurs when the internal body temperature rises several degrees above the normal body temperature of 98.6°F (37˚). The symptoms of hyperthermia are nausea, dizziness, drowsiness, and fainting.
Before You Begin Monday–Friday, 8:00 am–6:30 pm Eastern Standard Time (excluding holidays). To help us assist you, please note the product model number and serial number before calling. The model number is 831.108150. The serial number can be found on a decal attached to spa jet unit (see the front cover of this manual). Thank you for selecting the IMAGE® RENEW 815. The innovative spa offers the features and quality of a traditional hot tub at an affordable price.
Choosing a Location for the Hydrotherapy Spa There are many factors to consider when choosing a location to set up the spa. These factors vary depending on whether you use the spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the spa. If you set up the spa inside: If you set up the spa outside: 1. The spa will increase the level of humidity in your home. The location you choose should be well ventilated.
Assembly Before beginning assembly, carefully read the following information and instructions: • Assembly requires only the included air pump. Note: The included flat wrench is not required for assembly. The flat wrench is used to remove the filter cap (see pages 10 and 11). • Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. • Make sure that all parts are oriented as shown in the drawings.
2. Orient the dry side jet pack (A) as shown and place it near the three holes in the Inflatable Liner (29). 2 Slide the Temperature Probe Gasket (46) over the connector threads on the Temperature Probe Assembly (30). Insert the wire (not shown) through the small hole in the Inflatable Liner (29) and then push the Temperature Probe Assembly into the hole. Make sure that the threads on the connector are pushed fully through the vinyl liner.
5. Attach the nozzle on the air pump to the valve on the floor of the Inflatable Liner (29). Use the air pump to fill the bottom of the Inflatable Liner with air. Be extremely careful not to puncture the Liner. You will need to operate the pump by hand for this step. 5 29 Air Valve Air Valve Next, attach the nozzle on the air pump to the valve on the bolster of the Inflatable Liner (29). Fill the bolster until there are no wrinkles. 6.
Using the Hydrotherapy Spa The spa is designed to be used by up to three adults. The spa holds 268 gallons of water and offers an automatic, programmable heating and filtration system (70°F to 104°F). The guidelines below explain how to properly use and maintain the spa for your long-term enjoyment. same circuit. Replace the power cord immediately, if it becomes damaged. The power cord is equipped with a Ground Fault Circuit Interrupter (GFCI), located at the end of the power cord.
utes. You should now test the pH level of the water. Use the included test strips to check the pH of the water. Refer to the instructions on the test strip packaging to see how to use the test strips. insert the key and turn it counterclockwise a quarter turn. Always keep the buckles locked when the spa is not in use. Keep the keys in a safe place, out of the reach of children. If the level is too low, add one teaspoon from one of the “QUICK pHix It UP” packets to the water.
The spa jet unit features an automatic filter cycle and freeze protection. If the spa jet unit has not been operated for three hours, the pump will begin circulating the water for twenty minutes to filter any impurities. Also, if the water temperature falls below 40°F, the pump will begin circulating and heating the water to prevent the water from freezing.
Maintenance CLEANING THE INFLATABLE SPA LINER The liner should be cleaned with a mild soap solution. Do not use solvents. The liner should always be clean and dry before being moved or stored. CHECKING AND CLEANING THE FILTER The filter should be checked periodically for build-up of dirt and oil. If the filter needs to be cleaned, follow the steps below: 1. Turn off the power. 2. Remove the cover from the filter. Then pull the filter out of the unit. 3. Check the filter for any dirt or debris.
Trouble-shooting Most problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-888-936-4266, Monday–Friday, 8:00 am–6:30 pm Eastern Standard Time (excluding holidays). 1. SYMPTOM: THE SPA WILL NOT OPERATE b. The pump may have a bad bearing. Contact our customer service department. a. Check the power cord.
9. SYMPTOM: THE SPA JET UNIT CAVITATES DURING USE a. Adjust the water level. This usually occurs only when the water level is low. Add water until the filter and jets are covered. b. This problem is caused by excess air in the pump circulation system. Check to see if the primer cap is fully tightened. Prime the pump again and fully tighten the primer cap (see PRIMING THE SPA JET UNIT on page 10). c. Check that the–through the wall–connectors are tight. (See assembly step 3 on page 8.) 10.
NOTES 16
NOTES 17
CUSTOMER RECORD Model No.: Serial No.
Limited 90 Day Spa Warranty ICON Health & Fitness, Inc. (ICON), warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of 90 days from the date of purchase. Specifically covered under this warranty are the spa shell, the plumbing, the components, and the wood or tile exterior. This warranty extends only to the original purchaser.
Ordering Replacement Parts To order replacement parts, simply call our Customer Service Department toll-free at 1-888-936-4266, Monday–Friday, 8:00 am–6:30 pm; Eastern Standard Time (excluding holidays). To help us assist you, please be prepared to give the following information when calling: • The MODEL NUMBER of the product (831.
Remove this Part List/Exploded Drawing from the manual. Save this Part List/Exploded Drawing and the manual for future reference. Protect Your Spa Investment With the help of customer input, we have determined key information you need to be aware of to get the most enjoyment from your spa. Please review this summary carefully.
PART LIST—Model No. 831.108150 Key No. Qty.
11 45 9 29 4 27 27 10 38 18 10 26 25 17 39 18 38 19 42 42 52 42 23 42 42 6 53 16 8 34 51 53 50 37 51 49 48 7 2 50 3 48 49 14 32 31 44 12 40 1 24 43 54 21 28 13 36 43 36 52 5 5 22 46 30 33 35 41 47 36 20 36 15 5 5 5 EXPLODED DRAWING—Model No. 831.
