User's Manual

Writing mode - Auto Detect (DAO, TAO)

Supported DVD-ROM Drive* - EPO, TEAC

Supported DVD-RW Drive* - Plextor, TEAC, Lite-On, Asus, SONY

Chapter 2 Installation Procedure

When you purchase the CoolCopyD DVD Duplicator, the package may be packaged in the

following ways: controller only, whole duplicator without writer installed or a complete duplication

system.

2.1 Controller only

1. Before the installation, please prepare the necessary devices as following:

• DVD-ROM drive

• DVD-R/RW drive

• IDE case (2~10-bay chassis suggested).

• Hard drive and mobile rack (IDE-bus hard drive-Option)

• Switching power supply (300W suggested).

2. After the preparation as above and make sure:

• All IDE devices must be in master mode.

2.2 Whole duplicator without writer installed

• Unpack the duplicator.

• Prepare the DVD-R/RW writers according to the recommendation list. Please check with

the supplier about compatibility issues regarding unlisted DVD-R/RW drives.

• Assemble the duplicator according to your need.

• Make sure that the voltage setting is correct.

2.3 Completed duplication system

• Take the duplication system out of the package.

• Check the entire unit to see if there are any problems.

• Make sure that the voltage setting is correct.

• The hard drive is optional.

Hardware Connection of CoolCopyD1AL (DVD-Backup) without a HDD

CoolCopy1AL (CD-Backup)

DVD

ROM

DVD+/

Power