User's Manual

Copyright©2005 ILY Enterprise, Inc. All rights reserved.
25
Press the ENT button to enter Format HDD.
Use the arrow button to change Yes or No
setting. Then press ENT or ESC to go
back to the 12-04 menu.
If the system does not connect with hard drive,
the LCD will show the following message:
4.12.5 Verify HDD
This function verifies whether or not the hard disc or any of its partitions is working well.
Press ENT to enter Verify HDD.
Use the arrow button to change setting to Disk.
Then press ENT or ESC to go back to the 12-
05 menu.
Use the arrow button to change setting to Parti.
Then, press ENT or ESC to go back to the 12-05 menu.
4.12.6 Burn-in
This function is a burn-in test, which will simulate the copying process multiple times. After each
cycle, the DVDs on the DVD writers will be ejected automatically and re-inserted again for
continuous testing.
Press the ENT button to enter Burn-in.
The data will not be written on the blank
DVD discs and the discs will remain blank
after the test.
.
Use the arrow button to change the
RunContinuous, “1~10”, “10~100”,
“100~1000” setting. Press the ENT or ESC
button to go back to the 12-06 menu.
The system will repeat to erase and write
on the DVD-RW discs. Only DVD-RW discs can
be rewritten.
Use the arrow button to change the
RunContinuous, “1~10”, “10~100”,
“100~1000” setting. Press the ENT or ESC
button to go back to the 12-06 menu.
4.12.7 Update Firmware
This function will update your firmware to the latest version. Place the DVD disc, which contains
the latest firmware data (firmware DVD disc), into the DVD-ROM drive and the duplicator will find
All data will be
lost, format? Yes
There is no HDD!
12-05. Adv Setup
Verify HDD
Verify Disk or
Partition? Disk
Verify Disk or
Partition? Parti
12-06. Adv Setup
Burn-in
Burn-in
Test
Sel burn-in num:
Run Continuous
Burn-in
Erase&Copy
Sel burn-in num:
Run Continuous