User's Manual

LCD will show the information as the following screen:

When finished, the LCD will show the following message:

4.12 Adv Setup

This function allows you to change the system configuration. Changes should be made only when

you are fully familiar with the function. To enter the function, please press “ESC” button for 2

seconds.

4.12.1 UnderRun Protect

This function lets you control the Buffer Under Run Protection settings, such as Burn Proof,

SafeBurn, JustLink, Seamless Link, etc.

Press the ENT button to enter UnderRun Protect.

Use the arrow button to change the Setting. Then

press ENT or ESC to return to the 12-01 menu.

4.12.2 Overburn

This setting lets you decide whether to copy beyond the limit of the DVD or not.

Press the ENT button to enter Overburn.

Use the arrow button to change the On or Off

setting. Then press ENT or ESC to return to the

12-02 menu.

4.12.3 Read Error Skip

This function allows you to neglect any error that occurs during copying. You can use this function

to copy some defective DVDs.

Press the ENT button to enter Read Error Skip.

Use the arrow button to change the setting. Then

press ENT or ESC to go back to the 12-03 menu.

4.12.4 Format Hard Disk

This function allows you to partition the hard drive.

Erasing disc

03:24 (Full)

Full Erase

OK:01 Fail:00

12-01. Adv Setup

UnderRun Protect

12-02. Adv Setup

Overburn

12-03. Adv Setup

Read Error Skip

Off

12-04. Adv Setup

Format HDD