User's Manual

4.11.8 Auto Prescan

This setting allows you to automatically scan if the source DVD can be read correctly and also

tests the reading speed.

Press the ENT button to enter Auto Prescan.

Use the arrow button to change the “On” or “Off” Setting.

Then press ENT or press ESC to return to the 11-08 menu.

4.11.9 Eject Disc

The Eject disc setting allows three choices: Eject Good Only, Eject All Disc and Do Not Eject.

Press ENT button to enter the following figure:

Use the arrow button to select Eject Good Only.

Then press ENT or press ESC to return to the 11-

09 menu.

Use the arrow button to select Eject All Disc,

then press ENT or press ESC to return to the 11-

09 menu.

Use the arrow button to select Do Not Eject. Then press

ENT or press ESC to go back to the 11-09 menu.

4.11.10 Burn on the Fly

This setting lets you control the burning methods. When the setting is “On”, the data will copy

directly from source drive to the target drives. When the setting is “Off”, the data will load into a

partition of the hard drive first. Then, the copying will be completed.

Press ENT button to enter Burn On The Fly.

Use the arrow button to change the On or Off

setting. Then press ENT or press ESC to return to

the 11-10 menu.

If the system does not have a hard drive connected,

the LCD will show the following message:

4.11.11 Burn Mode

This setting lets you control the burning methods. There are two modes: Disc At Once (DAO) or

Track At Once (TAO). Default setting is DAO. Some DVD writers may support different writing

methods. If the method selected is not supported, duplicator will automatically switch to the other

one.

11-08. Setup

Auto Prescan

Off

11-09. Setup

Eject Disc

Eject Good

Only

Eject Disc

Eject All Disc

Eject Disc

Do Not Eject

11-10. Setup

Burn On The Fly

There is no HDD !