EN INSTRUCTION MANUAL
GENERAL OPERATING RULES Carefully read the instruction manual and warranty limitations The machine must be connected to a grounded power outlet. The machine must be kept clean by frequently washing the grid, the driptray, the capsule holder, the tank, the steam knob, and the air intake EXTREMELY IMPORTANT: never immerse the machine in water or put it in the dishwasher. The water contained in the tank must be replaced regularly.
EN table of contents MACHINE PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 IMPORTANT SAFEGUARDS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 USING THE ESPRESSO MACHINE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
machine parts A TEMPERATURE LED SIGNALS coffee ok - steam ok - signals when machine is heating, when temperature is not correct to make coffee, and signals a warning if boiler is empty B LEVER TO OPEN/ CLOSE CAPSULE COMPARTMENT C (INTERNAL) CAPSULE COMPARTMENT D BREWING UNIT E HOT WATER/STEAM WAND (PANNARELLO) F CUP HOLDING GRILL G FLOATING DEVICE TO SIGNAL FULL TRAY H LEVER TO RAISE DRIP TRAY I SELECTOR KNOB to deliver coffee hot water - steam L STEAM SWITCH 28 B A C D I L E F G H
EN N POWER CORD CUP HOLDER WATER TANK CONTAINER FOR USED CAPSULES (also contains some liquid) Q MAIN ON(I)/OFF(O) SWITCH R DATA PLATE (below) M N O P P O M Q R 29
important safeguards When using electrical appliances always follow the safety precautions below - Do not place the machine on, or near, electrical or gas burners or inside a hot oven 1 - Do not use the machine for purposes other than its intended use - The machine must be turned on only when being used.
EN a grounded power socket with minimum voltage of 6A if power required is 230Vac and 12A if power required is 110Vac IN CASE OF MALFUNCTIONING - If the plug and the socket are not compatible, have the plug replaced by qualified personnel - Do not use the appliance if the cord or plug are damaged or if the appliance shows signs of malfunctioning or if it has been damaged in any way. Send the machine to the nearest authorized technical assistance center to be checked or repaired.
machine signals Thanks to the Multi-purpose LED screen, the machine guides the user for correct operation BLUE Light solid The machine is ready to make an espresso, or produce hot water BLUE Flashing BLUE The machine is warming up to make espresso and/or hot water YELLOW Light solid The machine is ready to steam YELLOW Flashing The machine is warming up to create steam YELLOW RED Light solid Replenish the water system; fill the water tank and dispense hot water RED Flashing Slowly Boiler temperature
EN installation and start-up of espresso machine 1 2 HO 3 4 2 Before connecting the machine to a power supply, carefully read the safeguards listed in the previous chapter 5 Install the cup stand (included in the package) on the top part of the machine; insert the feet in the holes and press firmly 1 Remove the water tank by tipping top of tank slightly backwards first 2. Fill the tank with fresh drinking water until the MAX mark is reached 3.
turning on/off 1 2 3 4 BLUE Before switching on the machine check the water level in the tank; if necessary add water as described previously. To switch the appliance on, push the main on/off switch and move it into the "I" position 1.
EN drip tray adjustment 1 2 3 The X8 appliance is designed to adust to any type of cup you choose To adjust the drip tray, pull the lever located under the tray 1 When the desired position has been reached, pull the lever: position recommended for large cups 2 position recommended for small cups 3 Note: the adjustment must be made before starting the delivery of coffee 35
making coffee 1 2 3 The X8 machine is designed to function exclusively with “Metodo Iperespresso” capsules 1 4 5 Make sure that the temperature LED is blue and lit solidly Place a cup under the coffee group 2.
EN making cappuccino A 1 2 3 4 5 The machine is equipped with a steam arm to froth milk and prepare one or more cappuccinos Prepare one or more coffees following the steps outlined below Make sure that the capsule compartment is closed A Froth the milk as follows: Remove the capsule from the unit.
making hot water 1 3 2 4 YELLOW The steam nozzle fitted to the machine can also heat up water 5 Remove the capsule from the unit and any milk residue from the steam nozzle 1 Press the steam button 2; the steam icon on the front display flashes to indicate that the machine is heating up 3 Wait for the steam switch to light up (machine ready) followed by a short beep Fill a metal pitcher with the desired quantity of water to be heated Immerse the steam nozzle 4 in the water and open the steam knob by t
EN preparing coffee after generating steam After generating steam, the appliance cannot produce coffee until the correct coffee temperature has been reached (the temperature LED turns solid blue), or the taste of the coffee will be ruined 1 2 Therefore, after steaming, it is important to return to coffee mode by pushing the steam button 1 During the cooling stage (approx. 15 minutes) the temperature LED turns red and is flashing 2 RED To cool down the machine faster (approx.
descaling 1 2 3 The formation of limescale is a natural consequence of using of the machine 4 5 Descaling is necessary every 2-3 months; if the water is very hard, descaling should be done more frequently Descaling may be done with a non-toxic descaling product for coffee machines available in the market Note: to descale, remove the pannarello wand from the steam spout: loosen the ring nut without removing it and disassemble the top part of the pannarello wand from the steam spout 1 Switch the applian
EN 7 8 30 HO 9 10 2 H Leave the descaling solution inside the machine (switched off) for approx.
cleaning and maintenance 1 2 The appliance and its components must be cleaned at least once a week Keep the water in the tank fresh; wash the tank and fill it daily with fresh drinking water Do not use ethyl alcohol, solvents, abrasive sponges and/or aggressive chemicals - Switch the appliance off and disconnect the plug from the power socket 1 - Remove the water tank and wash it 2 - Remove the grill and wash it with warm water 3 - Remove the drip tray and wash it with warm water 4 - Remove the end of th
EN 5 6 7 - Remove the top part of the pannarello wand and wash it with warm water 7 8 9 - Wash the steam spout with a moist cloth - Extract the used capsule tray by grasping and pulling firmly 8 - Empty the residue in the capsule container (Caution: used capsules and some liquid from the coffee extraction will be in the tray) Insert the capsule container as follows: - Align the front part in the machine 9 - Insert the back part by pushing it firmly inside 10 10 43
technical data recommendations Casing: ABS To enjoy a high quality espresso, remember to: Internal boiler: Stainless steel - Change the water in the tank daily and empty the drip tray at least once a week Tank: 1.2 liters Pump: 15 bar Used capsule tray capacity: 7 capsules Steam arm See plate on the appliance Cup holder Electric cord length: 1.
EN PROBLEM SOLUTION IF PROBLEM PERSISTS Connect the plug to a correct power socket The machine does not turn on Move the main selector switch to the "I" position Fill the water tank The machine does not make coffee Check that the capsule was inserted correctly Turn the selector knob on the right side of the machine Carry out a decalcification cycle Contact Assistance The machine does not deliver any steam Check that the correct temperature has been reached Check that the steam wand is clean and not
warranty limitations The warranty does not cover damage caused by: - Calcium or by a lack of periodical decalcification - Operation with a voltage that differs from the one indicated on the plate - Improper use or use that is not compliant with the instructions - Internal modifications Furthermore the warranty does not cover repair costs on machines previously serviced by non-authorized technical assistance centers.
DICHIARAZIONE DI CONFORMITÀ CE - DECLARATION OF CE CONFORMITY DÉCLARATION DE CONFORMITÉ CE - CE KONFORMITÄTSERKLÄRUNG DECLARAÇÃO DE CONFORMIDADE CE - EG CONFORMITEITSVERKLARING illycaffè S.p.A.
15001825 illycaffè S.p.A. - Via Flavia 110 - 34147 Trieste - Italy - www.illy.
