Installation Guide

3OF4
INSTALLATION INSTRUCTIONS
STYLE NUMBER: UM-TST2788D1
Outlet Box
Outlet Box Screw
STEP 2:
a. Connect the House Ground Wire to the Fixture Ground
Wire.
b. Connect the House White (or Ribbed) Wire to the
Fixture Supply Wire (White or Ribbed Side).
c. Connect the House Black (or Red) Wire to the Fixture
Supply Wire (Black or Smooth Side).
d. Wrap each connection with approved electrical tape
and carefully stuff all of the connected wires into the
Outlet Box.
WHITE OR RIBBED
BLACK (OR RED) WIRE
GROUND WIRE
WHITE OR RIBBED
BLACK OR SMOOTH
GROUND WIRE
FROM HOUSE
FROM HOUSE
FROM HOUSE
FROM FIXTURE
FROM FIXTURE
FROM FIXTURE
Use Wire Connectors to connect the wires.
Mounting Screw
Backplate
Mounting Ball
STEP 3:
a. Carefully tuck all wires into the outlet box and position
the Fixture Body over the outlet box. Line up holes on
the Backplate and mounting holes on the folded edge of
the . Secure by threading Mounting Screws
into the mounting holes on the . Thread
screws into top first. Do not fully tighten. Thread screws
into bottom, tighten bottom screws with screwdriver.
Then , tighten top screws with screwdriver.
Crossbar
Crossbar
Crossbar
STEP 1:
Note: Prior to installation, close or cover the
sink drain and/or any vents near the installation site to
prevent loss of mounting hardware if dropped.
a. Remove the Crossbar from the Backplate on the Fixture
Body as shown in STEP 3.
b. Secure the Crossbar to the outlet box (not included)
with Outlet Box Screws.
Note: Fixture Body can be installed with the sockets
facing either up or down. The Crossbar should be
adjusted accordingly to match the holes on the
backplate of the Fixture Body.
Crossbar