Installation Guide

3OF4
INSTALLATION INSTRUCTIONS
STYLE NUMBER: UM-TST2318C2
STEP 2:
a. Connect the House Ground Wire to the Fixture Ground
Wire.
b. Connect the House White (or Ribbed) Wire to the
Fixture Supply Wire (White or Ribbed Side).
c. Connect the House Black (or Red) Wire to the Fixture
Supply Wire (Black or Smooth Side).
d. Wrap each connection with approved electrical tape
and carefully stuff all of the connected wires into the
Outlet Box.
WHITE OR RIBBED
BLACK (OR RED) WIRE
GROUND WIRE
WHITE OR RIBBED
BLACK OR SMOOTH
GROUND WIRE
FROM HOUSE
FROM HOUSE
FROM HOUSE
FROM FIXTURE
FROM FIXTURE
FROM FIXTURE
Use Wire Connectors (supplied) to connect the wires.
Outlet Box
Outlet Box Screw
Inner Backplate
Mounting Screw
Fixture Body
Inner Backplate
Backplate
STEP 3:
a. Carefully tuck all wires into the outlet box and position
the Fixture Body over the outlet box. Line up holes on
the Backplate and mounting holes on the folded edge of
the Inner Backplate. Secure by threading Mounting
Screws into the mounting holes on the Inner Backplate.
Thread screws into top first. Do not fully tighten.
Thread screws into bottom, tighten bottom screws with
screwdriver. Then tighten top screws with screwdriver.
STEP 1:
Note: Prior to installation, close or cover the sink drain
and/or any vents near the installation site to prevent
loss of mounting hardware if dropped.
. Secure the to the outlet box (not
included) with Outlet Box Screws.
a. Remove the Inner Backplate from the Backplate on the
Fixture Body as shown in STEP 3.
b Inner Backplate
Note: Fixture body can only be installed according to
the orientation shown in the illustration on Step 3,
sockets facing up. The Inner Backplate should be
adjusted accordingly to match the holes on the
backplate of the Fixture Body.