Installation Guide

5OF6

INSTALLATION INSTRUCTIONS

STYLE NUMBER: UM-TST1651A1

STEP 2:

a. Determine the Rods to be assembled according to your

desired hanging height.

b Pass the Supply Wires through the chosen Rods and

then thread Rods to Fixture Body together as shown.

Tighten until snug.

. Screw Swivels into the top end of the Upper Rod.

Please be sure the open end of the Swivels are the

same directions before tighten them until snug.

Suggested rod length for ceiling height.

8 ft ceiling will use (2) rods 16”.

9 ft ceiling will use (2) rods 16” and (2) rods 12”.

10 ft ceiling will use (2) rods 16”, (2) rods 12” and (4)

rods 6”.

Rod 16”

Rod 6”

Rod 12”

STEP 3:

a. Pass the Supply Wires and Ground Wires through

Swivel, the Ceiling Canopy, Flat Washer, Spring

Washer and Hex Nut.

b. Screw Nipples inside of Swivels and tighten until snug.

c. Pass the Ceiling Canopy, Flat Washers and Spring

Washers over Nipples as shown in the diagram. secure

them with Hex Nuts and hand tighten until snug.

Fixture boby

Swivel

Spring Washers

Hex Nut

Flat Washer

Ceiling

Canopy

Fixture boby

Nipple