Installation Guide

ManualsBrandsIllumina Direct ManualsKitchenDalea 3-Light Brushed Nickel Bath Vanity Light

ISSUED 09-2014

PACKAGE CONTENTS

1OF4

STYLE NUMBER: TST0957C1

WARNING:

CAUTION:

● Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by switching

off the circuit breaker or removing the fuse.

● These instructions are provided for your safety. It is very important that they are read completely before the

installation of your fixture. We strongly recommend that a professional electrician install the fixture.

● Disconnect fixture from the power source before replacing the bulb(s), making sure that bulb(s) had sufficient

time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may result.

● Do not touch the bulb with bare hands use a cloth or glove.

WARNINGS AND CAUTIONS

● Before beginning installation of product, make sure all parts are present. Compare parts with package contents

list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the

product. Contact customer service for replacement part.

● Estimated Assembly Time: 20 - 30 minutes

●

● : Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape,

safety glasses.

● 1-866-535-1869

● customerservice@illuminadirect.com

● www.illuminadirect.com

Bulb Recommended:

Tools Required

Phone #:

E-mail:

website:

.(3) 60W Clear G9 Halogen Bulbs

PREPARATION

www.illuminadirect.com

1-866-535-1869

UM-TST0957C1

PART

DESCRIPTION

QUANTITY

Shade

Fixture Body

Wire Connector

Outlet Box Screw

Socket Collar

(Pre-assembled to fixture body)

3pcs

4pcs

3pcs

1pc

Mounting Screw

(Pre-assembled to fixture body)

2pcs

Bulb Shield

Halogen Bulb

()G9

Inner Backplate

(Pre-assembled to fixture body)

1pc

Green Ground Screw

(Pre-assembled to Inner Backplate)

Summary of content (4 pages)

PAGE 1
www.illuminadirect.
PAGE 2
UM-TST0957C1 FINISH: Brushed Nickel 25” 7” 1 3.5” 1.5” 3 3.5” 4.5” 7” 4.5” Outlet Box Center 11” 5” 2 (3)60W Clear G9 Halogen Bulbs (Supplied) NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2" NO. PART NUMBER REPLACEMENT PART DESCRIPTION REQ.
PAGE 3
INSTALLATION INSTRUCTIONS STYLE NUMBER: UM-TST0957C1 STEP 1: Note: Prior to installation, close or cover the sink drain and/or any vents near the installation site to prevent loss of mounting hardware if dropped. a. Remove the Inner Backplate from the Backplate on the Fixture Body as shown in STEP 3. b . Secure the Inner Backplate to the outlet box (not included) with Outlet Box Screws. Note: Fixture Body can be installed with the sockets facing either up or down.
PAGE 4
INSTALLATION INSTRUCTIONS STYLE NUMBER: UM-TST0957C1 STEP 4: a. Remove the Socket Collar from the socket on the Fixture Body . Then place the Shade over the Socket on the Fixture Body as shown. Secure by threading the Socket Collar onto the socket on the Fixture Body. Hand-tighten until snug. Socket Collar Shade Socket Fixture Body STEP 5: a . This fixture uses clear G9 Halogen Bulbs (supplied). Maximum 60 watts. b . Insert bulb and sit properly into place. c.