Installation Guide

ManualsBrandsIllumina Direct ManualsKitchenEntia 5-Light Polished Chrome Track Lighting

ISSUED 05-2014

PACKAGE CONTENTS

1OF4

STYLE NUMBER: TST0038Q

WARNING:

CAUTION:

● Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by switching

off the circuit breaker or removing the fuse.

● These instructions are provided for your safety. It is very important that they are read completely before the

installation of your fixture. We strongly recommend that a professional electrician install the fixture.

● Disconnect fixture from the power source before replacing the bulb(s), making sure that bulb(s) had sufficient

time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may result.

● Do not touch the bulb with bare hands use a cloth or glove.

WARNINGS AND CAUTIONS

● Before beginning installation of product, make sure all parts are present. Compare parts with package contents

list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the

product. Contact customer service for replacement part.

● Estimated Assembly Time: 20 - 30 minutes

● (5) Clear G9 Halogen Bulbs 60W Maximum (Supplied).

● Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire Strippers, electrical tape,

safety glasses.

● 1-866-535-1869

● customerservice@illuminadirect.com

● www.illuminadirect.com

Bulb Recommended:

Tools Required:

Phone #:

E-mail:

website:

PREPARATION

www.illuminadirect.com

1-866-535-1869

UM-TST0038Q

PART

DESCRIPTION

QUANTITY

Wire Connector

3pcs

Socket Assembly

Shade

1pc

5pcs

1pc

Socket Collar Tool

5pcs

Socket Collar

(Pre-assembled to Socket Assembly)

Bulb

Bulb Shield

5pcs

Crossbar Assembly

1pc

Green Ground Screw

()Pre-assembled to Crossbar

Summary of content (4 pages)

PAGE 1
www.illuminadirect.
PAGE 2
TST0038Q FINISH: POLISHED CHROME 0.5” 10” 1 2 3 2.5” 2.5” Dia. 7” 5” 44.5” (5)60W Clear G9 Halogen Bulbs (Supplied) NO. PART NUMBER 1 G2684SH 2 I826SC 3 G2685BS NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2" REPLACEMENT PART DESCRIPTION REQ. SHADE OPAL ETCHED GLASS 3"D X 3"H 5 BULB 60W HALOGEN G9 CLEAR 5 BULB SHIELD GLASS 1.4"D X 1.
PAGE 3
INSTALLATION INSTRUCTIONS STYLE NUMBER: UM-TST0038Q STEP 1: a. Secure the Crossbar to the Outlet Box with Outlet Box Screws. b. Temporarily attach the Ceiling Canopy to the Nipple on the Crossbar, securing with the Finial. If the Ceiling Canopy is not snug against the wall, remove it from the crossbar and adjust the length of the Nipple by unscrewing the hex nuts. Turn the screws in or out of the crossbar until the correct length is achieved, then re-attach the Ceiling Canopy.
PAGE 4
INSTALLATION INSTRUCTIONS STYLE NUMBER: UM-TST0038Q STEP 4: A. Remove the Socket Collar from the Socket on the Socket Assembly. Place the Shade over the Socket as shown. Use the Socket Collar Tool, thread the Socket Collar onto the Socket to secure the Shade. Hand tighten until snug. Socket Shade Socket Collar Socket Collar Tool STEP 5 a. This fixture uses Clear G9 Halogen Bulbs. Maximum 60 watts (supplied). b. Insert bulb and sit properly into place. c.