User's Manual

Table Of Contents

4.3.2.SLAVE Class

4.3.2.1. Switching current area

Click the ZONE button to replace the current controllable area with up to 8 areas. when

switching to a AL area, indicates control of all areas. Assuming region 1, then the current region

will be region 2, region 2, region 3, region 4, region 5, region 6, region AL( whole region).

4.3.2.2. Send RX open device signal

Click the open button to send an open signal to the RX of the currently selected area.

4.3.2.3. Send off RX device signal

A user clicks the open button to send a closing signal to the RX of the currently selected area.

4.3.2.4. Sleep patterns

 If the user does not operate within 10 seconds SLAVE,SLAVE enter sleep mode, the digital

tube display is extinguished.

 The remote controller will exit sleep mode if the user presses any SLAVE button after the

SLAVE enters sleep mode. The digital tube display lights up and displays the currently

selected control area.

4.3.3.RX Class

4.3.3.1. Electrical equipment

After the equipment is connected to the power supply, the power indicator light will be long and

initialized. If an account has been established and the RX equipment is associated, the operating

indicator lights up long, otherwise the operating indicator lights out.

4.3.3.2. Change of equipment status

When the device receives a control signal from the HUB or SLAVE, the device output circuit is

turned on or off to control the power supply of external lighting lamps or electrical appliances.

Note: The state of the device does not last, so when the RX is powered off and re-energized, the