USER’S GUIDE V:1319-0324-10 ID200B DVD Player with Dock for iPod For the most up-to-date version of this User’s Guide, go to www.ilive.
Warnings And Precautions • • • • • • • • • • • • CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Avertissement: Pour réduire le risque d’incendie ou de choc électrique, ne pas exposer cet appareil sous la pluie et l’humidité. CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure.
FCC Warnings NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
DVD Player with Dock for iPod 4 Features Included • • • • • • • • • • • • • • • Remote control: requires 2 AAA batteries (not included) • Audio/video cable Made for iPod DVD player: DVD, DVD±R/RW CD player: CD, CD-R/RW, JPEG CD Progressive scan NTSC/PAL On-screen display for iPod and DVD Supports Universal docking brackets Basic iPod controls from remote Composite video output Component video output Coaxial digital audio output Remote control Soft eject iPod docking drawer AC power: built-in AC power
TABLE OF CONTENTS CUSTOMER HELPLINE | 1-314-621-2881 Introduction 6 SETUP 8 Basic Television Connection 9 Advanced Television Connection 10 iPod 11 DVD and CD 12 SETUP MENU 13 SOFTWARE UPDATES 14 Company Information 16 iLive | ID200B 5
introduction POWER Press to turn the DVD player off and on. DISC DRAWER OPEN/CLOSE OPEN/ CLOSE iPod Docking Drawer Press to open and close. DVD / CD PLAYER POWER PLAY/PAUSE PLAY/PAUSE Press to play or pause a DVD, CD, or iPod. STOP SOURCE STOP Press to stop a CD, DVD, or iPod during play. SOURCE Press to switch between CD/DVD and iPod mode.
POWER Press to power the DVD player off or on. OPEN/CLOSE Press to open or close the DISC DRAWER. OPEN/ CLOSE MUTE Press to mute the volume. SUBTITLE Press to cycle through the available subtitle options. ANGLE Press to activate the angle feature on supported DVDs. PROG Press to program a loaded disc to play tracks or chapters in a specified order. MUTE 1 2 3 4 5 6 7 8 9 10/0 10+ SUBTITLE ANGLE PROG GOTO AUDIO AUDIO Press to cycle through the available audio options.
Setup Power Plug the attached AC cord into a standard AC power outlet to power the home theater system.
BASIC TELEVISION CONNECTION Y Pb/Cb Composite Video Output Pr/Cr 120V ~ 60Hz VIDEO L R AUDIO OUT AUDIO INPUT COAXIAL DIGITAL VIDEO OUT VIDEO INPUT TELEVISION CUSTOMER HELPLINE | 1-314-621-2881 1 Plug the included RCA audio/video cable into the COMPOSITE VIDEO OUTPUT (yellow) on the DVD player and the composite video input (yellow) on a television.
ADVANCED TELEVISION CONNECTION Component Video Output Requires a component video cable (not included). 1 Plug a component video cable into the COMPONENT VIDEO OUTPUTS (green, blue, red) on the DVD player and the component video input (green, blue, red) on a television. 2 Plug the included RCA audio/video cable into the RCA STEREO AUDIO OUTPUTS (red and white) on the DVD player and the RCA stereo audio inputs (red and white) on a television.
iPod TV Interface Docking an iPod 1 When connected to a television, the docked iPod can be controlled from the on-screen display. 2 Use the DIRECTIONAL/ENTER buttons to navigate and make selections on the on-screen display. 1 Press the face of the iPod DOCKING DRAWER. 2 Connect the iPod to the connector inside the iPod DOCKING DRAWER. When the speaker is plugged in, using AC power, the docked iPod will charge. Playing an iPod 1 Follow the instructions for docking an iPod.
DVD and CD Playing a DVD or CD Playing a JPEG Photo CD 1 Connect the DVD player to a television and press the POWER button to turn the DVD player on. 2 Press the OPEN/CLOSE button to open the DISC DRAWER. 3 Load a DVD or CD into the DISC DRAWER, label side facing up, and press the OPEN/CLOSE button to close the DISC DRAWER. 4 The loaded DVD or CD will begin playing automatically. If it does not, press the PLAY/PAUSE button. 1 Press the SOURCE button to switch to DVD mode.
Setup Menu Accessing the DVD Setup Menu To access the DVD setup menu, press the SETUP button on the remote.
Software Updates Overview Just as Apple continues to update and improve it’s software and hardware, iLive works to remain up-to-date with the latest offerings from Apple. Continue to check the iLive website (www.ilive.net) for future updates to your ID200B. Checking your DVD player’s current software 1. Power on DVD player. 2. Remove any CD or DVDs from the DISC DRAWER. 3. Press “9735” using the NUMBER KEYPAD on the remote. 4.
Preparation You will need all of the following. • Computer connected to the Internet. • CD drive that is capable of reading and writing CD disk • Blank CD-R or CD-RW disc. Creating a Firmware Disk 1. Go to www.ilive.net and click on the support tab. Then select ID200B from the list of products. 2. Select DOWNLOADS, then click on the most recent firmware update and save file to your computer. 3. Load a blank CD into a CD writable drive. 4.
Company Information Green Initiative Environmental Commitment to ‘Protect for Today and Sustain for Tomorrow’ 2009 marks the official launch of DPI, Inc.’s corporate campaign for a greener and cleaner world. DPI and its four brands, iLive, WeatherX, Capri, and GPX, are building upon environmental initiatives introduced at all of their facilities to help formulate and sustain significant and important conservation efforts within its manufacturing and marketing communities.
