Specifications

NC-1031
NC-1031NC-1031
USB SLOT
3.5MM AUX
MIC
ANC ON / OFF
VOLUME+ / NEXT SONG
MFB (POWER ON/OFF;
ANSWER / END PHONE CALL;
PLAY / PAUSE)
VOLUME- / PREVIOUS SONG
LED
Push down ANC button. Green LED light will turn off. The ANC function
must be switched off by manual operation.
LED flash blue and red light alternately.
NC-1031 can make and receive calls hands-free with your compatible mobile
phone and listen to music from a compatible Bluetooth device, but they
should be with 10 meters (33 feet) of each other. The headset is compliant
with the Bluetooth Specification 5.0 support the following profiles: Headset
Profile (HSP) V1.6, Hands-free Profile (HFP) V1.7, Advanced Audio
Distribution Profile (A2DP) V1.3, and Audio Video Remote Control Profile
(AVRCP) V1.5 input rating 5V DC, 0.5A
To listen to music, connect the headset to phone or compatible Bluetooth
devices that support A2DP Bluetooth profile. The available music functions
depend on your Bluetooth devices. If you receive or make a call while
listening to music, the music is paused until the call ends.
To play a song, select in the music player and press the Play/Pause key on
the headset.
To pause or resume playing a song, press the Play/Pause key.
To select the next song during playback, press and hold “ + ”.
To select the previous song, press and hold “ - ”.
To increase the volume, quickly press “ + ” key, there will be beep town
when reaching max volume.
To decrease the volume, quickly press “ - ” key.
Passive Mode:
You can use NC-1031 as a wired headphone to save batteries. Simply
connect one end of the 3.5mm jack to 3.5mm audio cable to the bottom of
the left ear cup to your MP3 player. Inserting an audio cable disable the
wireless functionality.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure
requirement. in portable exposure condition without restriction.