Manual

Report No.: C140428Z01-RP1
FCC ID:
2AAHXMXH-BT800 Page 51/60
This report shall not be reproduced except in full, without the written approval of Compliance Certification Services.
TEST RESULTS
Below 1 GHz
Operation Mode:
TX
Test Date:
May 5, 2014
Temperature:
24
o
C
Tested by:
Eve Wang
Humidity:
52% RH
Polarity:
Ver. / Hor.
Frequency
(MHz)
Reading
(dBμV)
Correction
Factor
(dB/m)
Result
(dBμV/m)
Limit
(dBμV/m)
Margin
(dB)
Antenna
Pole
(V/H)
Remark
144.4600 51.20 -21.48 29.72 43.50 -13.78 V QP
199.7500 53.56 -22.73 30.83 43.50 -12.67 V QP
321.9700 51.99 -18.83 33.16 46.00 -12.84 V QP
399.5700 51.32 -16.10 35.22 46.00 -10.78 V QP
600.3600 40.84 -12.86 27.98 46.00 -18.02 V QP
700.2700 44.40 -11.94 32.46 46.00 -13.54 V QP
30.9700 42.46 -12.22 30.24 40.00 -9.76 H QP
152.2200 55.66 -21.93 33.73 43.50 -9.77 H QP
288.0200 52.35 -20.45 31.90 46.00 -14.10 H QP
317.1200 52.53 -19.00 33.53 46.00 -12.47 H QP
404.4200 51.60 -15.88 35.72 46.00 -10.28 H QP
480.0800 43.31 -14.36 28.95 46.00 -17.05 H QP
**Remark: No emission found between lowest internal used/generated frequency to 30MHz.
Notes:
1. Measuring frequencies from 9kHz to the 1GHz.
2. Radiated emissions measured in frequency range from 30MHz to 1GHz were made with an
instrument using Peak/Quasi-peak detector mode.
3. Data of measurement within this frequency range shown “ --- ” in the table above means the
reading of emissions are attenuated more than 20dB below the permissible limits or the field
strength is too small to be measured.
4. The IF bandwidth of SPA between 30MHz to 1GHz was 120kHz.
5. Frequency (MHz). = Emission frequency in MHz
Reading (dBuV) = Receiver reading
Correction Factor(dB/m) = Antenna factor + Cable loss – Amplifier gain
Actual FS (dBuV/m) = Reading (dBuV) + Corr. Factor (dB/m)
Limit (dBuV/m) = Limit stated in standard
Margin(dB) = Measured (dBuV/m) – Limits (dBuV/m)
Antenna Pole(V/H) = Current carrying line of reading