Manual

Report No.: C140428Z01-RP1
FCC ID:
2AAHXMXH-BT800 Page 50/60
This report shall not be reproduced except in full, without the written approval of Compliance Certification Services.
TEST PROCEDURE
1. The EUT is placed on a turntable, which is 0.8m above ground plane.
2. The turntable shall be rotated for 360 degrees to determine the position of maximum
emission level.
3. EUT is set 3m away from the receiving antenna, which is varied from 1m to 4m to find
out the highest emissions.
4. Maximum procedure was performed on the six highest emissions to ensure EUT
compliance.
5. And also, each emission was to be maximized by changing the polarization of
receiving antenna both horizontal and vertical.
6. Repeat above procedures until the measurements for all frequencies are complete.