Manual

Report No.: C140428Z01-RP1
FCC ID:
2AAHXMXH-BT800 Page 39/60
This report shall not be reproduced except in full, without the written approval of Compliance Certification Services.
6.8 SPURIOUS EMISSIONS
6.8.1. CONDUCTED MEASUREMENT
LIMIT
In any 100 kHz bandwidth outside the frequency band in which the spread spectrum or
digitally modulated intentional radiator is operating, the radio frequency power that is
produced by the intentional radiator shall be at least 20 dB below that in the 100 kHz
bandwidth within the band that contains the highest level of the desired power, based on
either an RF conducted or a radiated measurement. Attenuation below the general limits
specified in Section 15.209(a) is not required. In addition, radiated emissions which fall in
the restricted bands, as defined in Section 15.205(a), must also comply with the radiated
emission limits specified in Section 15.209(a) (see Section 15.205(c)).
MEASUREMENT EQUIPMENT USED
Name of Equipment Manufacturer Model Serial Number
Last
Calibration
Due
Calibration
Spectrum Analyzer Agilent E4446A US44300399
03/01/2014 03/01/2015
Remark: Each piece of equipment is scheduled for calibration once a year.
Test Configuration
TEST PROCEDURE
Conducted RF measurements of the transmitter output were made to confirm that the
EUT antenna port conducted emissions meet the specified limit and to identify any
spurious signals that require further investigation or measurements on the radiated
emissions site.
The transmitter output is connected to the spectrum analyzer. The resolution bandwidth
is set to 100 kHz. The video bandwidth is set to 300 kHz.
Measurements are made over the 30MHz to 26GHz range with the transmitter set to the
lowest, middle, and highest channels.
TEST RESULTS
No non-compliance noted
EUT
Spectrum
Analyzer