Manualshelf

Manual

ManualsBrandsiLike Electronics ManualsAudio EquipmentBluetooth Wireless Headset
11121314151617181920
Report No.: C140428Z01-RP1
FCC ID: 2AAHXMXH-BT800 Page 13 of 60
This report shall not be reproduced except in full, without the written approval of Compliance Certification Services.
6.2 PEAK POWER
LIMIT
The maximum peak output power of the intentional radiator shall not exceed the
following:
1. For frequency hopping systems operating in the 2400-2483.5 MHz band employing
at least 75 non-overlapping hopping channels, and all frequency hopping systems in
the 5725-5850 MHz band: 1 watt. For all other frequency hopping systems in the
2400-2483.5 MHz band: 0.125 watts.
2. Except as shown in paragraphs (b)(3) (i), (ii) and (iii) of this section, if transmitting
antennas of directional gain greater than 6dBi are used the peak output power from
the intentional radiator shall be reduced below the stated values in paragraphs (b)(1)
or (b)(2) of this section, as appropriate, by the amount in dB that the directional gain
of the antenna exceeds 6dBi.
3. The conducted output power limit specified in paragraph (b) of this section is based
on the use of antennas with directional gains that do not exceed 6 dBi. Except as
shown in paragraph (c) of this section, if transmitting antennas of directional gain
greater than 6 dBi are used, the conducted output power from the intentional radiator
shall be reduced below the stated values in paragraphs (b)(1), (b)(2), and (b)(3) of
this section, as appropriate, by the amount in dB that the directional gain of the
antenna exceeds 6 dBi.
MEASUREMENT EQUIPMENT USED
Name of Equipment Manufacturer Model
Serial
Number
Last
Calibration
Due
Calibration
Power Meter Anritsu ML2495A 1204003
03/01/2014 03/01/2015
Power Sensor Anritsu MA2411B 1126150
03/01/2014 03/01/2015
Spectrum Analyzer Agilent E4446A US44300399
03/01/2014 03/01/2015
Remark: Each piece of equipment is scheduled for calibration once a year.
Test Configuration
TEST PROCEDURE
The transmitter output is connected to the RF Power Meter. The RF Power Meter is set
to the peak power detection.
EUT Spectrum
Analyzer
Power Sensor +
Power Meter