User's Manual

TM70Pi V3.2 (11/03) 120021.pdf. 92
IKUSI reserves the right to change this information without prior notice
LIMIT VALUES:
Set the limits of the analogue output (+ Smin, Smin, smax + smax and Scero)  NOTE: These actions
involve movement of the manoeuvre to adjust!
 The adjustment of MAX and MIN values is performed with the manoeuvre moved for know which
output and which semiaxis is going to be adjusted.
 As you are pressing UP/DOWN keys, value will be updated on the screen.
 ZERO value of the output will be adjusted with the manoeuvre in the neutral position.
 The LCD will guide at all times to report that the five possible parameters are adjusted depending on
the position of the paddles.
 ZERO RELE ON: By entering this submenu is permanently activated the output of the expansion in
the absence of a order. This can be used to identify potential errors that cause unwanted movements.
POLARITY INV:
It allows the reverse polarity of outlets, such as:
CURVE TYPE:
Tour types of curve available:
 Type 0: Linear response.
 Type 1, 2 y 3: Exponential responses.
RAMPS:
The acceleration and/or deceleration ramp speed is defined for each semiaxis by a parameter that can take
a value between 0 and 15, default 0. Each of these values is a ramp time defined in seconds by the following
table:
0  without ramp 4  0,4 s 8  1,0 s 12  2,0 s
1  0,1 s 5  0,5 s 9  1,2 s 13  2,5 s
2  0,2 s 6  0,6 s 10  1,5 s 14  3,5 s
3  0,3 s 7  0,8 s 11  1,7 s 15  5,0 s
These values are modified by EEPROM recorder.