User's Manual

TM70Pi V3.2 (11/03) 120021.pdf. 91
IKUSI reserves the right to change this information without prior notice
21.2.1 – MENU 3.1 ADJUST
IMPORTANT: After adjustment for each parameter in each semiaxis, validate the setting before returning
back on the menu, otherwise would not be recorded. This validation is always performed by pressing
START. Finally and after setting all the parameters required, validate the 4. SAVE ALL menu to record in
the EEPROM all the settings.
In the next image we can see the different parameters that can be configured and will be described below:
By entering in this menu, the user is asked to activate the manoeuvre associated with the output to be
adjusted. Outputs associated with the manoeuvre will be displayed in the following format:
X: Number of the analogue output
Y: Output Number of the output
EXP_TYPE: Type of analogue output (A1P4RCAN, A2VCAN, A2ICAN)
The user has to select which of the exits wants to teleadjust. To do this, interested output should be flashing.
If there are two exits on screen, using the UP / DONWN can select the desired output. To confirm the
selection press START. At that time, and for a time will display the output you have selected.
X EXP_TYPE Y