User's Manual

TM70Pi V3.2 (11/03) 120021.pdf. 88
IKUSI reserves the right to change this information without prior notice.
21.1 - INTRODUCTION
Access to this option can be activated or deactivated by EEPROM, by EEPROM recorder and/or TM70Config, if
it is connected in the expansion the Jumper which enables Tele-alignment. Cards that support Tele-Alignment
are:
 A1P4RCAN(1 relay based potentiometric output card)
 A2VCAN (2 voltage analogue output card)
 A2ICAN (2 PWM current analogue outputs card)
A2ICAN and A2VCAN expansion cards are interchangeable, but the position and number of outputs will be
the same, also will require a modification of EEPROM due to differences in the output parameters. The new
expansion will be automatically recognized by the system. At the time of accessing to the Tele-Alignment menu,
the system makes a recognition of all the expansions connected to the CAN bus and supported outputs. All
information is synchronized between the transmitter and receiver.
The Tele-Alignment process requires the use of display LCD70 option (soft. version 3.1 or higher) or the TM70
Tele-Teaching support module (IKUSI Ref. 2305120-00A) designed for that purpose.
21.2 – TELE-ALIGNMENT PROCESS
The navigation through the software will be done by using the ▲ "UP" ▼ "DOWN", ENTER (validate selection)
and "ESC" (abort selection) keys, but are configurable by EEPROM and/or TM70Config. In situations where you
would press "UP" or "DOWN" repeatedly, there is a progressive move by holding down the key.
To access the Tele-Alignment menu must be pressed in sequence the "ENTER" (default) + "START".
This configuration is defined by EEPROM, but ENTER function may be replaced by any other manoeuvre by
TM70Config to change the access sequence to the Tele-Alignment menu.
The default menus are in English, but you can choose between English and Spanish by EEPROM and/or
TM70Config or Menu option (5. SELECT LANGUAGE).