User's Manual

TM70Pi V3.2 (11/03) 120021.pdf. 31
IKUSI reserves the right to change this information without prior notice.
9.4 - LCD70 DISPLAY OPERATING MODES.
OPERATING MODES:
The LCD70 display allows entering in these operating or special modes:
 EDIT CRANE LABEL: To edit the crane’s name.
 INPUT CALIBRATION: To calibrate the analogue voltage feedback 0–10v.
 OUTPUT CALIBRATION: To adjust through Tele Alignment option, the analogue
outputs.
 To enter to special operating modes, like “Programming a spare transmitter” (with the
“copy EEPROM” functionality) and “Base channel changing” (see Annex A and Annex
C).
TRIANGLE: Associated with the corresponding mechanism, it allows to enter to the base
channel changing mode and to increase the number of “tens” of the new base channel.
SQUARE: Associated with the corresponding mechanism, it allows to enter to the “Copy
EEPROM” functionality, and to increase the number of “units” of the new base channel.
Entering in configuration mode:
1. To access the Tele-Alignment menu must be pressed in sequence the "ENTER" (default
configuration) + "START".
2. The buttons ▲ “UP” and ▼ “DOWN” allow to navigate in the software and to select the
required option.
3. The “ENTER” function validates the selected option and with the ▲ “UP” and ▼ “DOWN”. It
also allows choosing the required value If there is a range of values available or for going to
a lower level of the software’s menu.
4. The “ESC” function aborts any selected option of the menu and it also allows returning to an
upper level of the software’s menu.
Entering to the “Base channel changing” mode:
Press the mechanism associated with the triangle symbol “▲” (see the
icon in the console box front plate), and then press “Start” button.
Entering to the “Copy EEPROM” mode:
Press the mechanism associated with the square symbol “■” (see the
icon in the console box front plate), and then press “Start” button.