User's Manual

TM70Pi V3.2 (11/03) 120021.pdf. 16
IKUSI reserves the right to change this information without prior notice.
ANNEX C.- BASE CHANNEL CHANGING.
Console box transmitters with software version V2.4 have implemented the base channel changing
functionality in a standard way (assigning symbols to mechanisms).
8) Identify the “▲” symbol associated to the corresponding maneuver
(base channel tens modification) and the “■” symbol associated to
the corresponding maneuver (base channel units modification),
preferably associated to the following mechanisms: pushbuttons,
selectors, joysticks, etc.
9) With the transmitter switched on, release the STOP button. Press the
mechanism identified with the symbol “▲” (pushbutton, selector, joystick, etc.) and then the “Start”
pushbutton. Although the “active order” status is signalized (red LED blinking and buzzer active),
wait until the LED is signaling orange continously.
10) The LED wiil show the current base channel information, using red and green pulses:
Number of green pulses = number of tens of the current base channel.
Number of red pulses = number of units of the current base channel.
11) Then the LED will light in orange colour continously.
12) Changing to the new base channel:
New channel “units”: press the “■” symbol as many times as the number of units of the new base
channel.
New channel “tens”: press the “▲” symbol as many times as the number of tens of the new base
channel.
13) The LED will show the new base channel information following the procedure of point 3).
14) Press STOP pushbutton; the new base channel will be recorded and the transmitter will be ready to
work in the new channel.