User's Manual

TM70Pi V3.2 (11/03) 120021.pdf. 15
IKUSI reserves the right to change this information without prior notice.
ANNEX B.- PROGRAMMING THE MACHINE IDENTIFICATION IN LCD TRANSMITTERS.
Transmitters with the LCD display option allow the operator to program a machine identification label
of up to 24 text characters. This identification is displayed on transmitter starting-up.
This text must identify the machine with a name that is commonly known by the workmen.
When first starting the transmitter you can edit/introduce this text as follows:
11. Identify in the Technical Data Sheet supplied with your system the actuator assigned to the
functions “Configuration”, “ENTER”, “UP”, “DOWN” y “ESC”
12. Introduce a battery and turn the ON/OFF key to ON .
13. Push in and then extract the STOP button and you will observe the LED pulse orange-green.
14. Press pushbutton “Configuration followed by START button and keep both pressed together
for 2 seconds and then you will enter the CONFIG mode.
15. Push “ENTER” to get into the Menu.
16. Move through the menu with pushbuttons “UP” y “DOWN” until reaching the EDIT LABEL
menu.
17. Push “ENTER”
18. Once you have entered into EDITING mode, there appears in the display the text "CRANE ??"
in which the first character blinks. From this point you can edit the name of the machine by
means of the push buttons “Down”, “Up”, “Enter” and “Escape”, whose functions are described
as follows:
 “DOWN”: To move for the list of established characters in descending order
 “UP”: To move for the list of characters established in ascending order
 “ESC”: To return to the previous character in the display.
 “ENTER”: To validate the published character and move to the following one, (towards
the right hand)
19. Push START to store the edited text. LCD will show the message “SAVED” for 2 seconds.
20. You exit the EDITING mode by pressing the STOP.