User's Manual

TM70Pi V3.2 (11/03) 120021.pdf. 14
IKUSI reserves the right to change this information without prior notice.
ANNEX A - PROGRAMMING A SPARE TRANSMITTER.
In case of damage to the transmitter, it is quickly possible to restore service, if a spare transmitter is
available. To achieve this we have to install into the spare transmitter the exact parameters of that to
be replaced.
These parameters are stored in an EEPROM memory module EP70, accessible from the exterior of
the transmitter. Switch off the damaged transmitter and extract the EP70 module by unloosening the
four screws, as shown, and then incorporate this module into the spare transmitter.
In cases where the damage to the transmitter prevents removal of the EP70 module, the spare
transmitter can be programmed with the memory module EP70 found inside the receiver.
To achieve this, proceed as follows:
7. Please indentify in the console upper part the symbol associated
to the special function“Copy EP” (SQUARE).
8. Being the spare transmitter off, remove its empty EP70 module as
described above, and insert the EP70 module from the receiver.
9. Introduce a charged battery, turn on the ON/OFF key, push and extract the STOP button. The LED
will pulse green for around 15 seconds.
10. To copy its contents into the internal memory of the transmitter
press the actuator or mechanism identified as “Copy EP”
followed by START, keeping both buttons pressed together while
LED blinks red. Once the LED start to blink orange, release the
pushbuttons and LED will lit green. In the LCD display models
the words “Reading...” and “Reading ok Change EEP” will be
indicated. In case the LED remains in red colour, (or the LCD
displays “Reading nok”), repeat the process.
11. When the copying process has completed, extract the EP70 and
replace it into the receiver. Insert a new EP70 module into the spare transmitter and again press the
actuator or mechanism identified as “Copy EP”. The LED will flash orange, which indicates that the
empty EP70 is being written with the stored parameters In the LCD display models the words
“Writing...” and “Writing ok” will be indicated. In case the LED remains in red colour, (or the LCD
displays “Writing nok”), repeat the process.
12. Afterwards press the STOP. This completes the programming processes.
SQUARE:
The actuator
or mechanism
associated to this symbol
will be used to copy the EEPROM.