User's Manual

70-M USER’S MANUAL
70-M V1.1 (05/07) 120009-0D.pdf IKUSI se reserva el derecho de modificar esta información sin previo aviso. 12
70-M V1.1 (05/07) 120009-0D.pdf IKUSI reserves the right to modify this information without prior notification.
5.2.- MAINTENANCE / TROUBLE SHOOTING GUIDELINES
RECEIVER’S LED SIGNALING
LED COLOUR STATUS REMARKS PROPOSED ACTION
POWER GREEN Switch On if powered Power supply OK Check the power supply
HARDOK GREEN
Solid green LED if no error
detected
Receiver hardware OK OK
Blinking during start up process
Please wait to finish the start up
process
HARDOK
RED
Solid red LED if one of these errors
appears:
- Watchdog activated /
Oscillator breakdown / wrong
ROM checksum
- Reset activated
Electronic board hardware
breakdown Replace the electronic board
- Blinking fast : wrong
EEPROM checksum / Data
corrupted.
Reprogramme EEPROM
SIGNAL GREEN
LED Off if no radio signal detected
(Squelch)
- LED On and the transmitter
switched Off indicates
occupied radio channel
- LED On and DATA
switched Off indicates radio
channel occupied by a non
IKUSI system
Verify transmitter’s radio and
battery
DATA GREEN LED Off if a wrong frame is received
Blinking if receiving good frames
LED Off and SIGNAL LED
On: Radio breakdown
Replace radios
Switched Off and DATA LED
switched On: no valid ID
If the radio channel is not busy:
verify transmitter’s selected ID
or reset receiver ID
ID
GREEN Blinking if a correct ID is received
SIGNAL; DATA and ID LED
On, indicates valid frames
from the transmitter. Correct
link.
OK
RELAY
GREEN STOP relay activated
ORDER
GREEN
Proportional lightning intensity
depending on the number of
activated outputs (PWM outputs); or
indicates that at least one output is
activated (RELAY outputs)