User Manual

Step 3: Exit Programming Mode
● After you have entered the desired remote code, press the Unlock
+ Alarm buttons simultaneously. The LED will go out.
● For a new remote: If no further LED flashes are seen, then the
remote was incorrectly set up. Return to Step 1 and re-enter
programming mode and your code. If the LED flashes, please use
Step 4 to verify your setup
● For a remote already configured: The remote should flash back
a verification code. See step 4 for verification of correct setup.
● For both new and configured: If the LED illuminates solid for 3
seconds, there was a hardware failure. Please contact tech
support.
3