Digital Housing i n s t r u c t i o n m a n u a l for Sony DSC-V3 Housing #6110.
Ikelite Digital Housing i n s t r u c t i o n Mode Dial Shutter Release m a n u a l Strobe Mount Night Framing Housing #6110.93 for Sony DSC-V3 Quick Release Button Lens Port Rubber Handles Lid Snap Tray FRONT VIEW Power External Strobe Connector Congratulations on your purchase of an Ikelite Digital Camera Housing. Ikelite has over 30 years of experience in the underwater photographic and lighting market.
Closing the Housing Checking Controls housing back 1. Place housing face down in your Once the housing has been closed, push the controls back into lap. place. Make sure they line up with the camera’s controls. 2. Check to see that there is an o’ring on the housing back and Turn Camera On that it is clean and in its proper Turn the camera on and operate each of the housing controls to location. Shutter get a feel for using the camera Power in the housing. Take a few 3. Guide the back onto the housing.
Maintenance The Ikelite Digital Housing should be given the same care and attention as your other photographic equipment. In addition to normal maintenance we recommend that the housing be returned to Ikelite periodically to be checked and pressure tested. 1. Do Not leave the camera and housing in direct sunlight for prolonged periods. Heat may damage the camera. 2. Do Not ship the camera in the housing. 3. Before using the housing, always check the tightness of the set screw in each control knob.
Photo Tips Photo Tips Cont. 1. The number one rule in underwater photography is eliminate as much water between camera and subject as possible. Get as close as you can to the subject, then use the zoom. If you are using flash, subjects beyond 6 feet (1.8m)will not have much color. 2. If the camera’s built-in flash is being used it is very close to the camera lens. The flash will light up any suspended particles in the water and they will be recorded in your picture. This effect is called backscatter.
