User's Manual
19
5. Press the port rmly towards the housing until the base of the
port is ush with the housing’s port mount. If there is resistance,
remove the port and re-check that the thumbscrews are loosened
and the o-ring is properly lubricated.
6. Tighten all three thumbscrews while holding the port rmly towards
the housing. The thumbscrews should thread in completely until
the head touches the port or extension body. If the screws are
difcult to turn and/or they bottom out before their heads are ush,
it is an indication that the port is not properly aligned.
» Proper alignment is critical to waterproof operation. Check
that your lens port is oriented correctly and fully seated before
entering the water.
» Zoom/focus gear parts and installation vary depending on the
lens you are using. Refer to the instructions included with the
zoom or focus gear for detailed installation information.
Setting Up An External Strobe
We recommend attaching an external strobe for the optimal color and
clarity in a wide variety of photographic situations, including daylight
photography.
This housing provides a direct electrical connection to the camera’s
external ash hotshoe via a manual ash hotshoe. An external strobe
may be triggered via electrical sync cord.