User Manual

Spike User Manual 3
1
Mounting Your Spike: Tablets
(or rst generation Spike)
IMPORTANT TO NOTE...
Mount your Spike to a smartphone or tablet case. You may wish to use two cases
- one with Spike attached to it and the other for general day-to-day use.
We recommend attaching your Spike to a hard case with a at back. It will
not attach securely to a soft or curved back design. Silicon cases should be
avoided.
Optimal surfaces to attach Spike to are metal and hard plastic surfaces.
1 Find the best location for your Spike on the
back of your smartphone or tablet case.
Place Spike close to the camera, but ensure that Spike
does not obstruct the view from your camera or ash.
To verify, start your camera app and hold your Spike
against the back of your smartphone or tablet to validate
correct placement.
For tablets, Spike may be orientated in a position that is
most comfortable when holding your tablet in landscape.
2 On the back of your Spike, peel off the protective
backing to expose the adhesive tape.
Peel a corner of the backing strip using your nger or a
small knife.
The adhesive tape adheres best at room temperature.
3 Make sure the selected position on your case is
clean, then position Spike onto your case. Press
down rmly for approximately 60 seconds
Ultimate bond strength is dependent upon the amount of
adhesive-to-surface contact developed. Be sure to press
rmly to develop this bond strength.
Tablet Case
Spike