Instruction Manual
Table Of Contents
- 1. Handling Precautions
- 2. General
- 3. Features
- 4. Camera Installation
- 5. Name of each section and its function
- 6. Connections
- 7. Angle and Lens adjustment
- 8. Operating Procedure
- 9. Warranty and after-sale service
- 10. Specifications
- 11. External Appearance
- 12. Setup Flow Chart
- 1. Precauciones de manejo
- 2. Generalidades
- 3. Características
- 4. Instalación de la cámara
- 5. Nombre de cada sección y su función
- 6. Conexión
- 7. Ajuste de ángulo y objetivo
- 8. Procedimiento de operación
- 9. Garantía y servicio postventa
- 10. Especificaciones
- 11. External Appearance
- 12. Setup Flow Chart
E-3
4. Camera Installation
4-1. Pre-work before installation
Make holes for
cables and to fix a
camera.
For the hole for
cable, a diameter of
the opening should
be at least 50mm to
60mm. Please make
it with utmost care
not to give damage to wires.
4-2. Mounting the camera
(Ceiling)
1. Put a rubber sealing gasket
on the housing base, paying
attention to allow for the screw
holes.
2. Take the dome cover off by
loosening the three screws with
the supplied L-form wrench.
3. Install the main unit to the
ceiling with supplied four
screws.
4. Replace the dome cover, after
making final camera setup
selections and lens adjustment.
4-3. Mounting the camera (Wall)
The way of installation is the almost same as to a
ceiling.
Install the main unit so that the switch becomes
upper side as shown in the illustration right and
set the “FLIP” in the setup menu to “V-FLIP”.
83.5
46
Holes for camera
fixing
Front side
Size of hole fo
r
cables on the ceiling
ø50 - ø6
0
Rubber sealing
gasket
Camera
Dome cover
L-form wrench
Attaching screws to
secure camera
(four)
Upper
Lower