Instruction Manual
Table Of Contents
- 1. Handling Precautions
- 2. General
- 3. Features
- 4. Camera Installation
- 5. Name of each section and its function
- 6. Connections
- 7. Angle and Lens adjustment
- 8. Operating Procedure
- 9. Warranty and after-sale service
- 10. Specifications
- 11. External Appearance
- 12. Setup Flow Chart
- 1. Precauciones de manejo
- 2. Generalidades
- 3. Características
- 4. Instalación de la cámara
- 5. Nombre de cada sección y su función
- 6. Conexión
- 7. Ajuste de ángulo y objetivo
- 8. Procedimiento de operación
- 9. Garantía y servicio postventa
- 10. Especificaciones
- 11. External Appearance
- 12. Setup Flow Chart
E-5
①
Lens fixing screws (elevation)
These are screws to fix the camera in the desired elevation position.
Fix these screws after setting the viewing position.
②
Vari-focal lens
Can be used with flexible angle of view using varifocal lens.
③
Switches for camera setup
Refer to Section 8 (Operating Procedure)
④
Test monitor output
Connect accessory MON.OUT output harness.
⑤
Power cable
This is a power cable. Non-polarity AC24V (AC 21.6V ~ 26.4V) or
DC12V has to be connected. Check the power voltage from the external
power supply before applying power to the camera.
* This installation should be made by a qualified service person and
should conform to all local codes.
⑥
Video Output cable (BNC)
This is the output of video signal. Connect this to a monitor or switcher.
⑦
Fixing holes (two key hole slots)
⑧
Dome Cover