Manual

Follow the above screen and set up the recoding speed, camera name Pre-Alarm and Post Alarm
images . After set up them properly, click Save button to save settings.
Pre-Alarm and Post Alarm images are recommended M-JPEG. If it is selected H.264, only I
frame is recorded. Each Camera1, Camera2 can be set different Condition 1～4 .
All the conditions are checked and worked by OR logic, so it will start recording when at least
one of the conditions it meets.
8-2-2. Condition 1
Caution：
○
Event
: Alarm Sensor details can be set by
6-4.DI (Sensor Input) / DO (Alarm Output)
.
○
Event
: Motion Detection details can be set by
6-3-3.Motion Detection
.
○
Event
: Number 1,2 are referred Stream number or motion detection.
If the number box is checked, it means Event recording had been set with this number for
Sensor/Motion detect. If two
number boxes are checked together, the recording is enabled only
when two Sensor/Motion detect are activated.
○
If it is used Motion Detection for Event , the detection area and Enable should be set by
6-3-3.Motion Detection.
54