User Manual

139269
Pre-tted
High pressure
139268
Low pressure
139269
High pressure
10004080
Pre-tted
Low pressure
10 AA-2256593-1
Before use: Unscrew the Aerator/Flow Guide with
a coin and allow the water to run freely for a few
minutes. Then screw the Aerator/Flow Guide back
in place up to the stop DO NOT OVER TIGHTEN.
To comply with UK water regulations, this
product shall be installed in accordance with the
following:
Inlet supply hoses shall be installed where light is
excluded.
Water supplies shall be at reasonably balanced
pressures from a common source (e.g. hot and
cold supplies both from the same storage or
both from a supply pipe). Where the tting is
supplied from unbalanced supplies (e.g. hot
and cold supplies from separate sources) an
‘Approved’ single check valve or some other no
less eective backow prevention device shall be
tted immediately upstream of both hot and cold
water inlets.
Check at regular intervals to make sure that the
installation is not leaking.