User Manual

54
FAULT CAUSE TROUBLESHOOTING
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
Spray arms were
blocked by tableware
so detergent was not
rinsed out.
● Check that the spray arms
are not blocked and can ro-
tate freely.
Detergent dispenser
was damp when deter-
gent was added.
● Only add detergent to a de-
tergent dispenser when dry.
Excessive formation of
foam occurs.
Hand washing-up li-
quid is present in dis-
penser for rinse aid.
● Immediately add rinse aid to
the dispenser.
→"Adding rinse aid", Page29
Rinse aid has been
spilled.
● Remove the rinse aid with a
cloth.
Detergent or appliance
care product used
causes excessive foam-
ing.
● Change the brand of deter-
gent.
Information on display panel
FAULT CAUSE TROUBLESHOOTING
Special salt refill indic-
ator lights up.
Insufficient special salt. ● Add "Special salt" →Page27.
Sensor does not detect
special salt tablets.
● Do not use special salt tab-
lets.
Refill indicator for spe-
cial salt does not light
up.
Water softening sys-
tem is switched off.
● "Setting water softening sys-
tem" →Page27
Refill indicator for rinse
aid lights up.
Insufficient rinse aid. 1. Add "Rinse aid" →Page29.
2. Set the amount of rinse aid
to be dispensed.
Refill indicator for rinse
aid does not light up.
Rinse aid system is
switched off.
● Set the amount of rinse aid
to be dispensed.
→"Setting the amount of rinse
aid", Page30
→"Setting the amount of rinse
aid", Page30